Ametek DCS-E 1kW Series Programming Manual Uživatelský manuál stáhnout pdf (Strana 31)

DLM-E Series and DCS-E Series Isolated Analog Programmer Operation

M51A Option 2-19

2.4 Remote Monitoring

Analog signals are available for monitoring the output voltage and current. These signals vary

proportionally to the output parameters, and have user selectable ranges of 0-5VDC, 0-10VDC,

or 4-20mA for an output change from zero to full scale. Refer to Table 2–3 for information on

configuring the monitors.

Isolated Analog

Programmer Connector J4

SW1 SETUP Switch

Output

Monitor

Signal

Signal Return Position Setting

Signal

Range

Voltage Pin-19 Pin-12 4 - V MON ON (1) 0-10VDC

Voltage Pin-19 Pin-12 4 - V MON OFF (0) 0-5VDC

Voltage Pin-4 Pin-12 N/A N/A 4-20mA

Current Pin-7 Pin-12 5 - I MON ON (1) 0-10VDC

Current Pin-7 Pin-12 5 - I MON OFF (0) 0-5VDC

Current Pin-24 Pin-12 N/A N/A 4-20mA

Table 2–3. Remote Monitoring

2.5 Remote Digital Status Signals

Digital signals are available for remote monitoring the operational status of the unit. Refer to

Table 2–4 for information on the characteristics of the signals.

Isolated Analog Interface

Connector J4

Logic Levels (with No

Signal Output Current)

Status

Indicator

Signal

Signal Return Asserted Not Asserted

Output

Resistance

VOLTAGE-

MODE

Pin-5 Pin-6 5V 0V 1kΩ

OVP Pin-17 Pin-6 5V 0V 1kΩ

FAULT Pin-18 Pin-6 5V 0V 1kΩ

Table 2–4. Remote Digital Status Signals

1 2 ... 26 27 28 29 30 31 32

Žádné komentáře

Ametek DCS-E 1kW Series Programming Manual Uživatelský manuál Strana 31