Ametek PLA-PLW Programming Manual Uživatelský manuál stáhnout pdf (Strana 61)

Parameters slew time, refer to model specifications | MIN | MAX

Unit ms

[SOURce:]VOLTage:SLEW:NEGative

This command sets the slew time of the voltage for negative going transitions. MINimum sets the slew

to the fastest possible time. MAXimum sets the slew to the slowest time.

Command Syntax VOLTage:SLEW:NEGative <NRf+>

Parameters Refer to model specifications | MIN | MAX

Unit ms

Query Syntax VOLTage:SLEW:NEGative?

VOLTage:SLEW:NEGative? MIN

VOLTage:SLEW:NEGative? M

Returned Parameters <NRf+> slew time in ms

[SOURce:]VOLTage:SLEW[:POSitive]

This command sets the slew time of the voltage for positive going transitions. MINimum sets the slew

to the fastest possible time. MAXimum sets the slew to the slowest time.

Command Syntax VOLTage:SLEW <NRf+>

VOLTage:SLEW:POSitive <NR1>

Parameters Slew time, refer to model specifications | MIN | MAX

Unit ms

Query Syntax VOLTage:SLEW?

VOLTage:SLEW? MIN

VOLTage:SLEW? MAX

VOLTage:SLEW:POSitive?

VOLTage:SLEW:POSitive? MIN

VOLGage:SLEW:POSitive? MAX

Returned Parameters <NRf+> slew time in ms

[SOURce:]VOLTage:TLEVel, VTR

Channel-Specific Voltage Command/Query. This command specifies the value of the

programmed voltage level for the TRANsient input when the electronic load is in the CV Mode. When

the Transient Subsystem is on, the electronic load input voltage will switch (under control of the

Transient Subsystem) between the main level and TLEVel at a rate determined by the present value

of SLEW.

In order for the input voltage level to switch, TLEVel must be set to a value greater than the main level.

If TLEVel is set to a valu

e belo

w the main level, no error is generated but switching will not occur until

the main level is subsequently below the value of TLEVel.

Command Syntax VOLTage:TLEVel <NRf+>

VTR <NRf+>

Parameters Voltage transient level value, refer individual model specification | MIN |

MAX.

Query Syntax VOLTage:TLEVel?

VOLTage:TLEVel? MIN VOLTage:TLEVel? MAX

VTR?

VTR? MIN

VTR? MAX

Returned Parameters <NRf+> returns the transient voltage level.

If the electronic load is not in CP Mode, the level will still be set, even if it

is less than the presently programmed input level.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 73 74

Komentáře k této Příručce

Žádné komentáře

Ametek PLA-PLW Programming Manual Uživatelský manuál Strana 61

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Ametek PLA-PLW Programming Manual