Ametek SFA Series Ethernet Programming Uživatelský manuál stáhnout pdf (Strana 42)

Ethernet Configuration and Remote Programming SG Series Programming

5-2

M550129-03 Rev K

Figure 5-2. SG Rear Panel with Ethernet/RS232 Options

1 – Ethernet (RJ-45) connector. Adjacent to the RJ-45 connector are two green LEDs.

If one of the LEDs is lit, the link is connected either to a hub switch or to another

host. If both are lit, the connection speed is 100MB.

2 – RS232 (RJ-type 6P6C) connector.

3 – Reset switch and green dual-purpose NET LED.

Reset switch (must be depressed until NET LED begins blinking, which could take

five or more seconds) returns configuration parameters to factory default settings

(see Section 4.3.2).

NET LED: when solid-lit, indicates Network Connectivity; blinking indicates

Instrument ID (See “Instrument ID” in Settings, Section 5.5.3). If the LED is off,

there is no Ethernet connection found by the power supply.

4 – Configuration Switch (may be 8-pin or 4-pin). For correct settings see Section

5.2.5)

5 –External User Control Signal Connector (see Section 5.3)

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 158 159

Žádné komentáře

Ametek SFA Series Ethernet Programming Uživatelský manuál Strana 42