Ametek BPS Series Programming Manual Uživatelský manuál stáhnout pdf (Strana 126)

AMETEK Programmable Power BPS / MX / RS Series SCPI Programming Manual

126 Manual P/N 7003-961 Rev AA

4.26 Trigger Subsystem

This subsystem controls the triggering of the AC/DC power source. See chapter 6 under

"Triggering Output Changes" for an explanation of the Trigger Subsystem. The INITiate

commands control the initialization of the transient system. The trigger subsystem must first

be enabled using the INITiate commands or no triggering action will occur. Refer to Figure

6-5 for a block diagram of the trigger system.

Subsystem Syntax

ABORt Resets the trigger system to the Idle state

INITiate

[:IMMediate] Initiates the system for one trigger

[:TRANsient]

:ACQuire

:CONTinuous sets if the initate continuous to (ON|OFF)

TRIGger

[:TRANsient]

:SOURce Sets the trigger source (IMMediate|BUS|EXT)

:COUNt Set if the trigger is controlled at every

count(NONE|ALL)

:ACQuire

:SOURce set the aquire trigger soure

(IMMediate|SYNChronize|BUS|TTLTrg)

:SYNChronize

:SOURce <source> Sets the trigger sync source (IMM|PHAS)

:PHASe <n> Sets the synchronous phase reference

:STATe? Return the trigger state (IDLE|ARM|BUSY)

ABORt

This command resets the transient trigger systems to the Idle state. Any output transient or

measurement that is in progress is immediately aborted. ABORt also cancels any lists or

pulses that may be in process.

Command Syntax ABORt

Parameters one

Examples ABOR

Related Commands INIT *RST *TRG

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 225 226

Žádné komentáře

Ametek BPS Series Programming Manual Uživatelský manuál Strana 126