Ametek BPS Series Programming Manual Uživatelský manuál stáhnout pdf (Strana 138)

AMETEK Programmable Power BPS / MX / RS Series SCPI Programming Manual

138 Manual P/N 7003-961 Rev AA

5.10 *SAV

This command stores the present state of the AC/DC power source to a specified location in

memory. Up to 8 states (including the transient list) can be stored in nonvolatile memory.

Command Syntax *SAV

Parameters 0 through 7

Related Commands PSC *RCL *RST

5.11 *SRE

This command sets the condition of the Service Request Enable Register. This register

determines which bits from the Status Byte Register (see *STB for its bit configuration) are

allowed to set the Master Status Summary (MSS) bit and the Request for Service (RQS)

summary bit. A 1 in any Service Request Enable Register bit position enables the

corresponding Status Byte Register bit and all such enabled bits then are logically ORed to

cause Bit 6 of the Status Byte Register to be set. See paragraph 7.5 for more details

concerning this process.

When the IEEE-488 BUS controller conducts a serial poll in response to SRQ, the RQS bit is

cleared, but the MSS bit is not. When *SRE is cleared (by programming it with 0), the source

cannot generate an SRQ to the controller.

Command Syntax *SRE <NRf>

Parameters 0 to 255

Default Value 0 (see *PSC command)

Example *SRE 255

Query Syntax *SRE?

Returned Paramters <NR1>(Register binary value)

Related Commands *ESE *ESR

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 225 226

Žádné komentáře

Ametek BPS Series Programming Manual Uživatelský manuál Strana 138